ORDERED

OpenMP* Fortran Compiler Directive: Specifies a block of code that the threads in a team must execute in the natural order of the loop iterations.

!$OMP ORDERED [clause [[,] clause ]]

block

!$OMP END ORDERED

clause

Is an optional clause. It can be one or more of the following:

SIMD

Applies an ordered region inside a SIMD loop.
THREADS

Applies an ordered region inside a PARALLEL DO loop. If no clause is specified, the directive behaves as if THREADS was specified.

block

Is a structured block (section) of statements or constructs. You cannot branch into or out of the block.

The binding thread set for an ORDERED construct is the current team. An ordered region binds to the innermost enclosing loop region.

An ORDERED directive with no clause or with the THREADS clause specified can appear only in the dynamic extent of a DO or PARALLEL DO directive. The DO directive to which the ordered section binds must have the ORDERED clause specified.

An iteration of a loop using a DO directive must not execute the same ORDERED directive more than once, and it must not execute more than one ORDERED directive.

One thread is allowed in an ordered section at a time. Threads are allowed to enter in the order of the loop iterations. No thread can enter an ordered section until it can be guaranteed that all previous iterations have completed or will never execute an ordered section. This sequentializes and orders code within ordered sections while allowing code outside the section to run in parallel.

Ordered sections that bind to different DO directives are independent of each other.

If the SIMD clause is specified, the ordered regions encountered by any thread will use only a single SIMD lane to execute the ordered regions in the order of the loop iterations.

Example

Ordered sections are useful for sequentially ordering the output from work that is done in parallel. Assuming that a reentrant I/O library exists, the following program prints out the indexes in sequential order:

  !$OMP DO ORDERED SCHEDULE(DYNAMIC)
        DO I=LB,UB,ST
          CALL WORK(I)
        END DO
        ...
        SUBROUTINE WORK(K)
  !$OMP ORDERED
        WRITE(*,*) K
  !$OMP END ORDERED

ORDERED

Example

See Also